Kodak A-61167 manual Power setup

2. Attach the other end of the IEEE-1394 (FireWire) cable to the host computer.

	WARNING: Make sure that the position of the IEEE-1394 (FireWire) cable
	connector end correlates to the IEEE-1394 port configuration
	before you plug the cable in. Damage to the scanner will
	occur if the cable is attached in the wrong position.
	IMPORTANT: The i200 Series Scanner should be the only item plugged in to
	the IEEE-1394 (FireWire) card on the host computer.
Power setup	One or more power cords may be supplied with the scanner. Use only the cord
	required for your power type. Dispose of any unneeded power cords properly.
	Use only the power supply that was provided with the scanner.
	CAUTION: The scanner and power supply must only be used indoors in a
	dry location.
	IMPORTANT: Do not substitute another power supply model or another
	manufacturer’s power supply.
	1. Press the side labeled “O” on the power switch to make sure that the
	power is off.

On/Off (I/O) power switch

NOTE: The power switch is on the power supply.

2.Attach the power cord for your power type to the power supply.

3.Attach the power supply to the power input on the back of the scanner.

14 A-61167 April 2005