Kodak I3400, I3200 manual Replacing the pre- separation pad Replacing the background strips

Replacing the pre- separation pad

Replacing the background strip(s)

Change the pre-separation pad when the frequency of multi-fed documents increases.

1.Open the scanner cover.

2.Remove the pre-separation pad by lifting the pad up and out of position.

3.Install the new pre-separation pad. Be sure it snaps into place.

4.Close the scanner cover.

In the rare case that you may need to replace the background strip(s), follow the procedures below.

1.Open the scanner cover.

2.Lift the tab on the left side of the upper background strip and slide the background strip to the left while lifting it out of position.

3.Insert the new background strip by aligning the tabs with the slots and slide it to the right until it snaps into place.

4.Repeat Steps 2 and 3 to replace the lower background strip.

5.Close the scanner cover.

A-61771 September 2012 5-11