Korg Speaker System owner manual Linking the arpeggiator to a program, Arpeggiator on/off

For example, suppose that you set “Pattern Select” to P0: UP, check “Latch,” set “Top Key” to B3 and “Bottom Key” to C–1. The arpeggiator will operate when you play keys in the range of B3 and below. Since “Latch” is on, the arpeggio will continue playing even after you release your hand from the keyboard. You can use the keys above B3 to play normally in realtime, to the accompaniment of the arpeggio. To change the chord that is being arpeg- giated, play a different chord in the range below B3.

“Top Velocity,” “Bottom Velocity”: The arpeggiator will operate when you play notes with a velocity (playing strength) that is within the specified range. Notes played with a velocity outside this range will be sounded normally, without regard to the arpeg- giator on/off.

6If you wish to save the edited program settings to internal memory, turn off memory protect in Glo- bal mode (☞p.37), and write the program (☞p.38).

Linking the arpeggiator to a program

If you want the arpeggiator settings written in a pro- gram to be selected when that program is selected, check Program for “Auto Arpeggiator” (Global P0: Basic tab).

Arpeggiator settings in Combi- nation, Song, and Song Play modes

In Combination, Sequencer, and Song Play modes, the TRITON provides dual arpeggiator functionality that lets you use two arpeggio patterns simultaneously. The settings in each of these modes are made in the similar way.

As an example, the following explanation shows how to make settings in Combination mode. For a detailed explanation and example settings (☞p.39, 73, 107 in the Parameter Guide).

The dual arpeggiator functionality lets you do the fol- lowing things.

•Assign an arpeggiator for each timbre. Choose from Off, (arpeggiator) A, or (arpeggiator) B.

		☞step5
•	Independently specify whether A and B will
	operate.	☞step6
•	Select an arpeggio pattern and set parameters
	independently for A and B.	☞step7

•Make Scan Zone settings so that you can use keyboard range or playing velocity to switch between normal playing and arpeggiated playing, or to switch between arpeggiators A and B.

☞step8

•Make settings for timbres that will be silent when the arpeggiator is not operating, and will sound

only when the arpeggiator is operating. ☞step0

Arpeggiator on/off

Each time you press the ARPEGGIATOR [ON/OFF] key, the arpeggiator will be switched on or off. When on, the LED will light. The selected arpeggio pattern will begin when you play the keyboard. The on/off setting is saved when the program is written into memory.

When “Arpeggiator Assign” is Off, turning it on will not make the arpeggiator operate if “Arpeg- giator Run are unchecked.

Arpeggiator settings

Select any desired programs for the timbres 1–4 that we will be using as an example here.

1Select Combination P1: Edit-Program/Mixer.

Select any desired programs for the timbres 1–4 that we will be using as an example here.

2In Combination P2: Edit-Trk Param, select the MIDI Channel tab.

For the timbres that you will be using, set “Status” to INT, and set “MIDI Channel” to Gch or to the global MIDI channel (set in Global P1: MIDI “MIDI Channel”).

98