Korg Speaker System Realtime control knobs 1, 2, 3, A mode controls, Ribbon controller

4To release the locked condition, press the [SW1] key once again.

Ribbon controller

When the [SW1] or [SW2] key function is set to Ribbon Lock, the sound produced by moving the ribbon con- troller can be held even after the ribbon controller is released.

When the [SW1] key is set to Ribbon Lock and is oper- ating as a Toggle switch, the lock function can be used as described in the following example.

1Press [SW1] (the [SW1] key LED will light).

2Move your finger to left or right on the ribbon con- troller. The sound will change.

3Even when you remove your finger from the rib- bon controller, the sound at that point will be held.

This is the “locked” condition.

4To release the locked condition, press the [SW1] key once again.

3Even when you apply further pressure to the key- board, the sound at the moment you pressed [SW1] key will be held.

This is the “locked” condition.

4To release the locked condition, press the [SW1] key once again.

Realtime control knobs

[1], [2], [3], [4]

These knobs can be used to control the filter cutoff fre- quency and resonance, the amp and filter EG, volume, portamento time, pan, pitch LFO, or the send levels to the master effects, etc.

1Press the [REALTIME CONTROLS] key to switch the function of the realtime controllers to A mode or B mode.

Each time you press the key, A mode or B mode will be selected alternately, and the corresponding LED will light.

The selected mode will light.

2Rotate the desired knob to control the sound, etc.

When the [SW1] or [SW2] key function is assigned to JS X & Ribbon Lock, JS+Y & Ribbon Lock, or JS–Y Ribbon Lock, both locking functions will apply simultaneously.

After touch

When the [SW1] or [SW2] key function is set to After Touch Lock, the sound produced by applying pressure to the keyboard can be held even after the keyboard is released.

When the [SW1] key is set to After Touch Lock and is operating as a Toggle switch, the lock function can be used as described in the following example.

1After playing a note, apply pressure to the key- board (after touch). The sound will change.

2While maintaining the pressure on the keyboard, press [SW1] (the [SW1] key LED will light).

A mode controls

In A mode, knobs [1]–[4] will control/edit the follow- ing functions.

Placing the knobs in the center (12 o’clock) position will produce the values specified by the program parameters.

Knob [1]: LPF CUTOFF

Adjust the cutoff frequency of the low pass filter. When you adjust the cutoff frequency of the filter, the brightness of the sound will change. The effect will depend on the settings of the program parameters, but normally, rotating the knob toward the left will darken the sound, and rotating it toward the right will brighten it.

Level

LPF

Frequency

Low Cutoff High

frequency

Knob [2]: RESONANCE/HPF

Adjust the resonance level of a low pass filter or the cutoff frequency of a high pass filter.

The content that is controlled will depend on the filter type specified by the program.

26