Korg Speaker System owner manual Connecting pedals etc, Connections to MIDI equip- ment

Play mode and output the sound from the OUTPUT jacks, connect a mic or an external audio source to the AUDIO INPUT 1 and 2 jacks.

●For details on connections when sampling in Sam- pling mode (☞p.78).

●For details on connections when outputting from the OUTPUT jacks in other modes (☞p.109).

4. Connecting pedals etc.

Foot pedal connections

A foot pedal controls etc.

Connect a separately sold Korg assignable pedal such as the XVP-10 or EXP-2 to the rear panel ASSIGN- ABLE PEDAL jack.

The function controlled by the foot pedal is specified in Global: P2 “Foot Pedal Assign” (☞p.125). (☞p121, 220 in the Parameter Guide)

Foot switch connections

A foot switch controls sostenuto, soft pedal on/off, arpeggiator on/off, to select programs or combina- tions, and to start/stop the sequencer etc.

Connect a separately sold Korg foot switch such as the PS-1 to the rear panel ASSIGNABLE SWITCH jack. The function that will be controlled by the foot switch and the polarity of the foot switch can be set in Global: P2 “Foot Switch Assign,” and “Foot Switch Polarity” (☞p.125). (☞p.121, 219 in the Parameter Guide)

Damper pedal connections

A damper pedal applies a damper effect as you play. Connect a separately sold Korg DS-1H damper pedal to the DAMPER jack of the TRITON. If a DS-1H is con- nected, half-damper effects can be produced.

The polarity of the pedal is set in Global P1 “Damper Pedal Polarity” and the sensitivity is set in Global P1 “Half Damper Calibration.” (☞p.115, 121 in the Parame- ter Guide)

5.Connections to MIDI equip- ment

The keyboard, controllers and sequencer of the TRI- TON control and play an external MIDI tone generator, and an external MIDI keyboard or sequencer plays the TRITON’s tone generator.

●Use MIDI cables to connect the MIDI connectors of the TRITON to the MIDI connectors of your external MIDI device (☞p.111).

6. Connections to a computer

An IBM PC (compatible) or Apple Macintosh com- puter can be connected to the TRITON, so that the TRI- TON’s keyboard, controllers and sequencer can transmit data to the computer, and so that the com- puter can play the TRITON’s tone generator.

●Connect the TRITON’s TO HOST connector to the appropriate port of your computer (☞p.112).

7. Connections to a SCSI device

If the separately sold EXB-SCSI option is installed, you can connect the TRITON to a SCSI-compatible device (hard disk drive, CD-ROM drive, etc.).

For the EXB-SCSI installation refer to p.237 in the Parameter Guide.

16