36The effects in detail | Amp Model section
AMP 1 (CLEAN COMBO)
The Clean Combo’s clean sound is very tight “n” twangy, with a deep, taut,
piano-like bass. When pushed hard the bass tends to crumble. The original amp
doesn’t have a Presence control but does have a Bright Switch. The Presence con-
trol on your SV-1 emulates this switch when “off” and “on,” plus all points in-
between!
Original’s tube compliment: 2 x 12AX7s & 2 x 7025s & 2 x 12AT7s (a.k.a.
ECC81) in the preamp, 4 x 6L6s in the power amp.
AMP 2 (CALIFORNIA)
This was a blackface guitar amplifier made in Southern California during the
early ’60s. Its 45 Watts into 4 x 10" speakers earned it a shimmering tone. This
amp’s medium output and powerful sound was a favorite in clubs.
Original’s tube compliment: 4 x 12AX7 in the preamp, 1 x 5AR4 rectifier tube, 2
x 6L6 tubes in the power amp, plus 2 x 12AT7 tubes.
For illustration and parameter’s description, please refer to AMP1.
Parameters Values Notes
Pre Vol 0…100 The degree of distortion is determined by the level of
input signal and the setting of PRE VOL. Raising the
PRE VOL setting will cause the entire volume level to
increase. Use the AMP VOL parameter to adjust the
volume level.
Amp Vol 0…100
Bass 0…100 Adjusts the bass frequencies.
Middle 0…100 Adjusts the middle frequencies.
Treble 0…100 Adjusts the treble frequencies.
Presence 0…100 Boosts the upper frequencies above the normal treble
control range for added high-end.
SV1-100-EditorGuide-EFGI.book Page 36 Wednesday, June 3, 2009 12:35 PM