The effects in detail | Reverb/Delay Effects section – 49
English
SPRING REVERB
This models the spring reverb system used in some amps.
TAPE ECHO
This models one of the most respected analogue tape echo machines ever made.
In the original, the “echo” is produced by a playback head and the exact “delay
time” is set by varying the motor speed. Many professionals prefer these “lo-fi”
units because of the warm, dark echoes they produce.
Parameters Values Notes
Time 0…99 Sets the reverb time, which will differ depending on
the reverb type.
Lo Damp 0…100 Adjusts the attenuation of the low-frequency range.
Hi Damp 0…100 Adjusts the attenuation of the high-frequency range.
Pre Delay 0…70 Sets the initial delay before the reverberation begins.
By adjusting this setting you can clarify the definition
of the original sound.
Mix 0…100 Adjusts the mix amount of the reverb.
Parameters Values Notes
Time 0…2700 Sets the delay time.
Feedback 0…100 Adjusts the amount of feedback.
Tone 0…99 Adjusts the tone of the delay.
Lo Damp 0…100 Adjusts the amount of low-frequency attenuation.
Mix 0…100 Adjusts the mix amount of the delay.
SV1-100-EditorGuide-EFGI.book Page 49 Wednesday, June 3, 2009 12:35 PM