48 – The effects in detail | Reverb/Delay Effects section

PLATE REVERB

This models a type of reverb unit that works by vibrating a metal plate instead of

a spring. It is adjusted to a fairly short reverb time. This reverberation is charac-

terized by a rapid attack, and is suitable for percussive playing.

HALL REVERB

This models the reverberation of a concert hall with numerous echoes.

Parameters Values Notes
Time 1…30 Sets the reverb time, which will differ depending on
the reverb type.
Lo Gain -30…30 Adjusts the attenuation of the low-frequency range.
Hi Gain -30…30 Adjusts the attenuation of the high-frequency range.
Pre Delay 0…200 Sets the initial delay before the reverberation begins.
By adjusting this setting you can clarify the definition
of the original sound.
Mix 0…100 Adjusts the mix amount of the reverb.
Parameters Values Notes
Time 1…30 Sets the reverb time, which will differ depending on
the reverb type.
Lo Gain -30…30 Adjusts the attenuation of the low-frequency range.
Hi Gain -30…30 Adjusts the attenuation of the high-frequency range.
Pre Delay 0…200 Sets the initial delay before the reverberation begins.
By adjusting this setting you can clarify the definition
of the original sound.
Mix 0…100 Adjusts the mix amount of the reverb.
SV1-100-EditorGuide-EFGI.book Page 48 Wednesday, June 3, 2009 12:35 PM