Connecting the VP-747

6 Connecting the VP-747

The VP-747is a universal presentation matrix switcher / scaler that lets you choose what sources to connect to the inputs. For example, you can connect just five sources: an RGBHV source, two DVI / HDMI sources, an HDTV source and an RGBS source (as the example in Figure 3 shows).

To connect1 the VP-747as illustrated in the example in Figure 3, do the following:

1.Connect the following video sources:

An HDMI source to the INPUT DVI / HDMI 1 connector

An HDMI source to the INPUT DVI / HDMI 2 connector

An HDTV satellite receiver source to the R/PR, G/Y/CV, and B/PB/C BNC INPUT 6 connectors (PR/Y/PB)

An RGBHV computer graphics source to the R/PR, G/Y/CV, B/PB/C, HS/CS and V BNC INPUT 8 connectors (R, G, B, H, V)

2.Connect the PROGRAM OUT:

DVI / HDMI connector to the plasma display

VGA 15-pin HD connector to the analog display

R/PR, G/Y, B/PB, (PR, Y, PB) BNC OUTPUT connectors to the YUV acceptor, for example, a projector (PR,Y, PB)

3.Connect the PREVIEW OUT R/PR, G/Y, B/PB, HS and VS BNC OUTPUT connectors to the display (R, G, B, H, V)

4.Connect the power cord2.

5.If required, connect:

A PC via RS-232, see Section 7.1

The Kramer VP-727AAudio Switcher via the To AUDIO UNIT RS-485 port3, see Section 7.2

The Kramer VP-727TPresentation Switcher Control Panel via the TO CONTROLLER mini XLR port3

The ETHERNET port3, see Section 7.4

1 Switch OFF the power on each device before connecting it to your VP-747. After connecting your VP-747, switch on its power and then switch on the power on each device

2 We recommend that you use only the power cord that is supplied with this machine 3 Not shown in Figure 3 (see Section 7.3)

12

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Page 15
Image 15
Kramer Electronics user manual Connecting the VP-747,  The Ethernet port3, see Section