2.Connect a DVI video source (for example, a computer graphics source) to the LOCAL INPUTS DVI connector, and the computer’s unbalanced stereo audio source to the LOCAL AUDIO INPUT DVI connector.

3.Connect an HDMI video source to the LOCAL INPUTS HDMI connector.

4.Connect the TP OUT RJ-45 connector to a compatible TP receiver up to 50m (164ft), for example, PT-572+.

5.Connect the S/PDIF RCA digital audio output to an audio acceptor (for example, a DAT recorder).

6.Connect the balanced audio 5-pin terminal block (see Section 6.1) to an audio acceptor (for example, a balanced stereo audio amplifier).

7.Connect up to ten remote, contact closure input selection switches to the REMOTE terminal block (see Section 6.2).

8.Connect the Ethernet RJ-45 TP port directly or via a LAN to a PC controller. Alternatively, you can connect a PC and/or controller to the:

RS-232 port (see Section 6.3)

RS-485 port (see Section 6.4)

9.Connect the power cord.

Note: When signal sources are disconnected from inputs, signal acceptors (for example, a projector) may not go into standby mode automatically. We therefore recommend that you turn off the VP-81SIDNand/or the acceptor.

Note: When using the PT-572+in conjunction with the VP-81SIDNdo not connect the 12V power supply to the PT-572+.

VP-81SIDN - Connecting the VP-81SIDN 8x1 Digital Step-In Switcher

11

 

 

Page 15
Image 15
Kramer Electronics VP-81SIDN user manual