Wechsel des Druckkopfes:Netzstecker ziehen!

ErdenSiesichvordemEntfernenoder demEinbaudesDruckkopfesam Gehäuse.Dadurchwirdder Druckkopf vor einer statischen EntladungIhresKörpersüberden DruckkopfzurErdegeschützt.

1.Deckel öffnen.2.Gehäuse abschrauben (2 Schrauben innen, 2 außen)

3.Druckkopf (5) hochklappen, Etiketten und Transfer- band aus dem Drucker entfernen.

4.Druckkopf herunterklappen.5.Feststellschraube (3) für Druckkopf vollständig lösen.
ReplacingthePrinthead:Unplugthepowercable!

Ground yourself to the chassis before youremoveorinstalltheprinthead. This will prevent a static discharge fromyourbodythroughtheprinthead to ground, possibly destroying the printhead.

1.Open the cover.2.Disassemble the chassis (2 screws inside, 2 outside).

3.Lift the printhead (5) and remove the label stock and transfer ribbon from the printer.

4.Close the printhead.5.Loosen the printhead locking screw (3).

1

2

3

4

5

Bild 7

1

Öffnung im Montageblech

Figure 7 1

Opening in assembly plate

 

2

Druckkopfkabel

2

Printhead flat cable

 

3

Feststellschraube für Druckkopf

3

Printhead locking screw

 

4

Buchsenleiste des Druckkopfkabels

4

Printhead connecting cable

 

5

Druckkopf

5

Thermal printhead

6.Flachband-Kabelhalter (6) öffnen.7.Druckkopfkabel zur Druckkopfseite durch die Öffnung(1) schieben.

8.Druckkopf (5) vorsichtig nach vorn herausziehen, bis Buchsenleiste (4) zugänglich wird.

9.Buchsenleiste (4) und Stecker am Druckkopf zunächst an der Unterseite vorsichtig mit einem Schraubendre- her wechselseitig auseinanderhebeln, bis die Buchsen- leiste an der Oberseite vollständig abgehebelt werden kann.

10.Buchse an den neuen Druckkopf anschließen.11.Druckkopf vorsichtig in die Halterung zurückschieben.12.Druckkopf-Feststellschraube (3) mit Hand leicht anziehen!
6.Open the flat cable holder (6).7.Push the printhead cable through the opening (1) toward the printhead.

8.Pull printhead (5) carefully out of the front side until the connecting cable (4) can be accessed.

9.Carefully loosen connection cable and connector of the printhead at the bottom side using a screwdriver alternately on the left and the right until the cable can be taken off completely.

10.Connect the cable to the new printhead.11.Carefully slide the new printhead back into the mount.12.Tighten printhead locking screw (3) slightly by hand.

24