5.5 Justage Druckkopfabstützung

Beim Bedrucken schmaler Etiketten (Breite < ca. 60 mm) ist es möglich, daß der Druckkopf in dem Bereich, in dem kein Material liegt, direkt mit der Druckwalze in Kontakt kommt.

Der Druckkopf liegt nicht mehr plan auf dem Etikett auf.Mögliche Folgen:Ÿvorzeitiger Verschleiß des Druckkopfes durch Abrieb,ŸUnterschiede in der Druckintensität zwischen den Etikettenrändern.Aktivieren Sie bei schmalen Etiketten dieDruckkopfabstützung!

5.5 Adjusting the Printhead Support

When printing on narrow labels (width less than 2.5 in or 60 mm), it is possible that the printhead will come into direct contact with the drive roller, this will cause the printhead to not evenly contact the label material.

The following faults can occur:Ÿpremature wear on the printhead caused by friction;Ÿinconsistent print image density from one edge of the label to the other.

Notice

Activatetheprintheadsupportwhen
using narrow labels!
1.Feststellschraube (2) lösen.

2.Feststellschraube (2) im Formloch (3) verschieben. Exzenterförmige Druckkopfabstützung (4) wird gedreht und stützt den Druckkopf (1).

EmpfehlungfürbreiteEtiketten:Stellung "2a"
(Abstützung nicht wirksam)
EmpfehlungfürschmaleEtiketten:Stellung "2b"
Entscheidend für die Einstellung ist
dasDruckbild!

 

3.Feststellschraube (2) anziehen.
1.Loosen the locking screw (2).

2.Move the screw (2) as required within the adjustment slot (3). This will cause the cam shaped printhead support (4) to rotate, in effect, providing a higher or lower base on which the printhead (1) rests.

Recommendationforwidelabels:Position "2a"

 

 

(no support)
Recommendationfornarrowlabels:Position "2b"

Notice

Adjust the cam to the best image
possible!

 

 

 

3.Tighten the locking screw (2).

1

4

2 a

3

2 b

Bild 13

1

Druckkopf

Figure 13 1

Thermal printhead

 

2

Feststellschraube

2

Knurled locking screw

 

3

Formloch

3

Adjustment slot

 

4

Druckkopfabstützung

4

Printhead support

30