6. Remarks
Operation Notes
General Cautions
•While printing, do not turn off the main switch.
•While printing, do not open the door or covers.
•While printing, do not unplug the power cord.
•While printing, do not move the machine.
•Keep corrosive liquids, such as acid, off the machine.
•Open and close the door and covers softly.
•Do not put anything except originals on the machine.
•Do not spill liquid on the machine.
•When opening or closing the door or covers, keep hold of them so they don't fall.
•When removing the drum unit from the machine, be careful not to let the drum unit fall.
•Do not modify or replace any parts other than the ones specified in this man- ual.
•Do not operate the machine without covers. You might get your fingers caught in the machine, or the machine might be damaged because, for exam- ple, dust or the like might get inside.
•Since some parts of the machine are sharp and might cause injury, touch only the parts specified in this manual.
•If you clean rubber parts with benzine, wipe them with a dry cloth after- wards.
•Always turn the machine off when you have finished printing for the day.
•If the machine must be transported by vehicle, please contact your service representative.
•Make sure to make a few trial prints to check the image position because the image position of the trial print might not correspond with that of the origi- nal.
•If the image registration is not consistent, slow the printing speed down to Setting 1.
•When performing duplex or multicolored printing, leave the printed paper for a while before the next printing in order to let the ink dry on the printed paper. If this is not done, feed roller marks will appear on the print image.
97
