Lantronix 1-T2, MSS100 manual Installation, MSS Components

Installation MSS Components

2 - Installation

This chapter covers the installation of the MSS in an Ethernet network and the attachment of a serial device. Basic knowledge of networking installation is assumed. Read this section completely before continuing.

2.1 MSS Components

The MSS front panel has a male DB25 serial connector. The following Þgure shows an MSS1 front panel. The MSS100 rear panels is more narrow.

Figure 2-1:MSS1 Front Panel

Serial

DB25 Serial Port

The MSS rear panel has an RJ45 Ethernet connector, a BNC Ethernet connector (MSS1-T2 only), a reset button, and a power connector. The following Þgure shows an MSS1 rear panel. The MSS100 rear panels is more narrow, and does not include a BNC connector.

Figure 2-2:MSS1 Rear Panel

10BaseT	10Base2
	6V DC
	Reset

RJ45 Ethernet Port	Power Connector
BNC Ethernet Port	Reset Button
(MSS1-T2 only)

NOTE: When the reset button is pressed and held during the power up and boot procedures, the MSS returns to its factory default configuration.

2 - 1