Lenovo 6446 Installing a Remote Supervisor Adapter II SlimLine, Hard disk drive cable connector 4

1	Hard disk drive cable connector 4 - 7	4	ServeRAID-MR10i SAS/SATA
			controller
2	Hard disk drive cable connector 0 - 3	5	Hard disk drive cable 4 - 7
3	Battery	6	Hard disk drive cable 0 - 3

7.Connect any required cables to the adapter.

Attention:

vWhen you route cables, do not block any connectors or the ventilated space around any of the fans.

vMake sure that cables are not routed on top of components under the PCI riser-card assembly.

vMake sure that cables are not pinched by the server components.

8.Perform any configuration tasks that are required for the adapter.

If you have other optional devices to install, do so now. Otherwise, go to “Completingthe installation” on page 30.

Installing a Remote Supervisor Adapter II SlimLine

An optional Remote Supervisor Adapter II SlimLine can be installed only in a dedicated connector on the system board. After the Remote Supervisor Adapter II SlimLine is installed, the systems-management Ethernet port on the rear of the server is active.

Note: Earlier versions of the Remote Supervisor Adapter II SlimLine might not work in this server. See http://www.lenovo.com/support/ for information about which versions of the Remote Supervisor Adapter II SlimLine are supported.

The following illustration shows how to install a Remote Supervisor Adapter II

SlimLine.

Chapter 2. Installing optional devices 27