Note: The Ethernet controller for Ethernet connector 1 supports Serial over LAN (SOL).
You do not have to set any jumpers or configure the controllers. However, you must install a device driver to enable the operating system to address the controllers. For device drivers and information about configuring the Ethernet controllers, see the Broadcom NetXtreme II Gigabit Ethernet Software CD that comes with the server. To find updated information about configuring the controllers, complete the following steps.
Note: Changes are made periodically to the Lenovo Web site. The actual procedure might vary slightly from what is described in this document.
1.Go to: http://www.lenovo.com/support.
2.Enter your product number (machine type and model number) or select Servers from the Select your product list.
3.Select Servers from the Brand list.
4.From Family list, select ThinkServer RD120, and click Continue.
Using the RAID configuration programs
Use the IBM ServeRAID Configuration Utility program and ServeRAID Manager to configure and manage redundant array of independent disks (RAID) arrays. Be sure to use these programs as described in this document.
vUse the IBM ServeRAID Configuration Utility program to:
–Perform a
–View or change IDs for attached devices
–Set protocol parameters on hard disk drives
vUse ServeRAID Manager to:
–Configure arrays
–View the RAID configuration and associated devices
–Monitor operation of the RAID controller
Consider the following information when using the IBM ServeRAID Configuration Utility program and ServeRAID Manager to configure and manage arrays:
vThe
vHard disk drive capacities affect how you create arrays. The drives in an array can have different capacities, but the ServeRAID controller treats them as if they all have the capacity of the smallest hard disk drive.
vTo help ensure signal quality, do not mix drives with different speeds and data rates.
vTo update the firmware and BIOS code for an optional ServeRAID SAS controller, you must use the IBM ServeRAID Support CD that comes with the ServeRAID option.
Using the IBM ServeRAID Configuration Utility program
Use the IBM ServeRAID Configuration Utility programs to perform the following tasks:
vConfigure a redundant array of independent disks (RAID) array
vView or change the RAID configuration and associated devices
44ThinkServer RD120 Types 6444, 6445, 6446, and 6447: Installation Guide
