Lenovo RD120 manual Completing the installation

Attention: In a dc power environment, only trained service personnel other than Lenovo service technicians are authorized to connect or disconnect power to the dc power supply. See the documentation that comes with each dc power supply.

3.Remove the cover (see “Removing the cover” on page 31).

4.Follow the instructions that come with the drive to set any jumpers or switches.

5.Attach the drive retention clip
1 to the side of the drive using the alignment pins
2.

6.Slide the drive into the CD/DVD drive bay until the drive clicks into place.

If you have other optional devices to install or remove, do so now. Otherwise, go to “Completing the installation.”

Completing the installation

To complete the installation, complete the following steps:

1.If you removed the PCI riser-card assembly, replace the riser-card assembly (see “Installing the riser-card assembly” on page 34).

2.If you removed any air baffles, replace the air baffles (see “Installing the microprocessor air baffle” on page 36 and “Installing the DIMM air baffle” on page 38).

3.If you removed the server cover, place the cover-release latch
1 in the open (up) position. Insert the bottom tabs of the top cover into the matching slots in the server chassis. Press down on the cover-release latch to lock the cover in place.

74ThinkServer RD120 Types 6444, 6445, 6446, and 6447: User Guide