Lexmark Optra C710 manual Fax Menu

Fax Menu (continued)

Menu item	Values
Fax Buffer	Disabled
	Auto*
	3K to maximum size allowed
	You can configure the size of the fax input buffer to meet the requirements of your system. If
	the limited size of the input buffer is preventing you from continuing work in your application
	each time you receive a fax, you may want to increase the buffer size.
	The maximum size depends on the amount of memory in your printer, the size of the other link
	buffers, and whether the Resource Save setting is On or Off. To maximize the range for the
	Fax Buffer size, you can disable or reduce the size of the parallel, serial, network, infrared, or
	LocalTalk buffer. Choose the Auto setting to let the printer automatically calculate a buffer size
	proportional to the total amount of available printer memory. In most cases, Auto is the recom-
	mended setting.
	See page 91 for a listing of the default buffer sizes for all the interface ports.
	Note: Changing the Fax Buffer setting automatically resets the printer.
Job Buffering	Off*
	On
	If you have an optional disk installed in your printer, you can choose to have jobs that are sent
	to the LocalTalk port spool to the disk. Spooling jobs to disk may decrease the time required
	for the printer to accept data from an application, and therefore free the application faster for
	other work. Since disk memory provides permanent storage, job buffering to disk also
	prevents the loss of print job data if the printer loses power.
	The Job Buffering menu item is not displayed if the formatted hard disk is defective, is Read/
	Write or Write protected, or if Job Buffer Size is set to Disabled in the Setup Menu.
	See page 92 for more information about job buffering.
	Note: Changing the Job Buffering setting automatically resets the printer.
*Factory default

68 Chapter 3: Menus