Lexmark Optra C710 manual Message from the display, Message and continue printing

Attendance messages (continued)

Message	Action
52 Flash Full	There is not enough space available to hold the resources you want to store in
	flash memory.
	• Press Go to clear the message and continue processing. Downloaded fonts
	and macros not previously stored in flash memory or disk are deleted.
	• Reset the printer. Press Menu> or <Menu. The Job Menu is displayed. Press
	Menu> or <Menu until Reset Printer appears on the second line. Press Select.
53 Unformatted Flash	The flash memory installed in your printer has not been formatted. You must
	format the flash memory before downloading resources.
	Press Go to clear the message. To format flash memory, select Format Flash from
	the Utilities Menu.
54 Serial Option x Error	The printer has detected a protocol error on the specified serial interface. Make
	sure the serial interface parameters are set up correctly and you are using an
	appropriate serial cable.
	• Press Go to clear the message and continue printing. The job may not print
	correctly.
	• Reset the printer. Press Menu> or <Menu. The Job Menu is displayed. Press
	Menu> or <Menu until Reset Printer appears on the second line. Press Select.
54 Serial x Fax Connection Lost	The printer has detected the external modem that was once connected to the
	serial port is no longer responding. If the printer has been configured to receive
	faxes from a serial port and the Fax Port setting is not set to disabled, it will poll the
	modem. If it detects the modem connection is missing, it displays the attendance
	message. If the modem connection is re-established, the printer removes the
	message from the display.
	If the modem has been intentionally disconnected, you can press Go to clear the
	message and continue printing.
54 Std Par ENA	An External Network Adapter (ENA) that was once connected to the standard
Connection Lost	parallel port is no longer responding. The printer only recognizes the missing
	connection when the printer power is first turned on.
	• Make sure the cable connecting the ENA and the printer is securely attached.
	Turn the printer off and then on again to see if the printer recognizes the
	connection.
	• Press Go to clear the message. The printer erases any reference to the ENA
	and then resets.
54 Network x Software Error	The printer software has detected that a network port is installed and cannot
	establish communications with it.
	Press Go to clear the message. The printer disables all communications to the
	associated network interface. No data can be transmitted through this interface.
	You can program new firmware in the network interface through the parallel port
	after this message has been cleared.

154 Chapter 8: Understanding printer messages