
MAINTENANCE/INSPECTION PROCEDURE
2. Required Maintenance
The recording density of a VCR(VCP) is much higher than that of an audio tape recorder. VCR(VCP) components must be very precise, at tolerances of 1/1000mm, to ensure com- patibility with the other VCRs. If any of these components are worn or dirty, the symptoms will be the same as if the part is defective. To ensure a good picture, periodic inspection and maintenance, including replacement of worn out parts and lubrication, is necessary.
3. Scheduled Maintenance
Schedules for maintenance and inspection are not fixed because they vary greatly according to the way in which the customer uses the VCR(VCP), and the environment in which the VCR(VCP) is used.
But, in general home use, a good picture will be maintained if inspection and maintenance is made every 1,000 hours. The table below shows the relation between time used and inspection period.
Table 1
When |
|
|
|
|
|
|
| |
inspection is | About 1 | About 18 | About 3 | |||||
necessary | ||||||||
year | months | years | ||||||
| ||||||||
Average |
|
|
|
|
|
|
| |
hours used |
|
|
|
|
|
|
| |
per day |
|
|
|
|
|
|
| |
One hour |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
Two hours
Three hours
4.Supplies Required for Inspection and Maintence
(1)Grease : Kanto
(2)Isopropyl Alcohol or equivalent
(3)Cleaning Patches
(4)Grease : Kanto
5. Maintenance Procedure
5-1) Cleaning
(1)Cleaning video head
First use a cleaning tape. If the dirt on the head is too stubborn to remove by tape, use the cleaning patch. Coat the cleaning patch with Isopropyl Alcohol. Touch the cleaning patch to the head tip and gently turn the head(rotating cylinder) right and left.
(Do not move the cleaning patch vertically. Make sure that only the buckskin on the cleaning patch comes into contact with the head. Otherwise, the head may be dam- aged.)
Thoroughly dry the head. Then run the test tape. If lso- propyl Alcohol remains on the video head, the tape may be damaged when it comes into contact with the head surface.
(2)Clean the tape transport system and drive system, etc, by wiping with a cleaning patch wetted with Isopropyl Alcohol.
NOTES:
1It is the tape transport system which comes into contact with the running tape. The drive system consists of those parts which moves the tape.
2Make sure that during cleaning you do not touch the tape transport system with excessive force that would cause deformation or damage to the system.
Drum
(Rotating Cylinder)
Cleaning Patch
Head Tip
Touch this section of cleaning
Coat With Isopropyl Alcohol patch to the head tip and gently turn the Drum (Rotating Cylinder)