Liebert XDP user manual Equipment Handling, Handling With Skid, Removal from Skid

Product Description

1.3Equipment Handling

! WARNING

Risk of unit falling over. Can cause injury or death.

The Liebert XDP is top-heavy. Use extreme caution and care when moving and installing this unit.

NOTE

Personnel should be properly trained and certified to move and rig equipment.

1.3.1Handling With Skid

•Always keep the unit upright, indoors and protected from damage.

•If possible, transport the unit using a forklift truck. Otherwise use a crane with belts or cables. In either case, do NOT press on the top edges of the packaging.

•If using a forklift, make sure the forks (if adjustable) are spread to the widest allowable distance to still fit under the skid.

•When moving the skidded unit with a forklift truck, do not lift the unit any higher than

6" (152mm) off the ground. If circumstances require the unit to be lifted higher than 6" (152mm), great care must be exercised and all by-standing personnel are to be no closer than 20 feet (6m) from the lift point of the unit.

! CAUTION

Risk of structural interference. Can cause equipment or building damage.

While on the skid, the unit is too tall (83" [2108mm] overall height) to fit through a standard doorway. Any attempt to move the unit, while skidded, through a standard doorway will cause damage to the unit and to the building.

1.3.2Removal from Skid

Liebert recommends using dual hand trucks or a similar method to remove the Liebert XDP from the skid. This is to ensure that both ends of the unit are firmly secure and to provide a good means of unit mobility.

1.Always keep the unit upright, indoors and protected from possible damage.

2.Remove the exterior packaging. Leave the plastic bag over the Liebert XDP until the unit has been moved to its final location. The bag will protect the painted panels against scuffing.

3.Remove two (2) corner tie-down brackets from one side of the unit, on a non-runner notch side of the pallet. Remove eight (8) lag bolts from two (2) end deck boards on the same end where the tie-down brackets were removed (refer to Figure 2).

Figure 2 Tie-down brackets and lag bolts to be removed

Remove these 4 lag bolts to free deck boards

Remove these 2 tie-down brackets

Remove these 4 lag bolts to free deck boards

2