Lincoln Electric 5000 manual Figure B.2 Gasoline Engine Controls

B-4		OPERATION		B-4
	FIGURE B.2 – GASOLINE ENGINE CONTROLS
2		9	3

POWER ARC 5000

1

1.FUEL SHUTOFF VALVE

2.FUEL TANK AND CAP

3.MUFFLER

4.STOP SWITCH

5.AIR CLEANER

GASOLINE ENGINE CONTROLS

6

4

5

7

10

8

6.CHOKE

7.RECOIL STARTER

8.OIL DRAIN PLUG

9.OIL FILL AND DIP-STICK

10.LOW IDLE SPEED PULL DOWN

See Figure B.2 for the location of the following fea- tures:

1.FUEL SHUTOFF VALVE: Stops the flow of gaso- line from the fuel tank to the carburetor. Should be closed by turning full clockwise whenever you are finished using the POWER ARC 5000. Open fuel shutoff valve by turning full counterclockwise before starting the engine.

2.FUEL TANK AND CAP: Holds 5.5 gallons (20.8 liters) of unleaded gasoline.

3.MUFFLER: Reduces engine noise output. Does not serve as a spark arrester. See SPARK ARRESTER in the INSTALLATION section of this manual.

4.STOP SWITCH: Stops the engine by grounding the ignition circuit.

5.AIR CLEANER: Filters intake air to the carburetor. See ENGINE MAINTENANCE in the MAINTE- NANCE section of this manual for details about the specific type of air cleaner to use.

6.CHOKE: Provides a richer air/fuel mixture for cold engine starting conditions. See the topic ENGINE OPERATION, below, for details on setting the choke.

7.RECOIL STARTER: Manual, rope-type starter. The handle position allows easy starting from either ground level or pickup-truck level.

8.OIL DRAIN PLUG: Permits convenient draining of engine oil during maintenance.

9.OIL FILL AND DIP-STICK: Permits convenient checking of oil level and filling of engine oil.

10.LOW IDLE SPEED PULL DOWN: Pull this lever out and latch it to reduce the engine idle to 2200 RPM when a low idle is desired. Release lever and let engine return to high idle 3700 RPM before aplying any type of load.

POWER ARC 5000