INSTALLATION | ||
|
|
|
POWER CORD CONNECTIONS TO TWIST- LOCK PLUGS
Refer to the appropriate diagram above for proper connection of power cord wires to the
PLUGS AND HAND-HELD EQUIPMENT
For further protection against electric shock, any 120 volt
CIRCUIT BREAKERS
The POWER ARC 5000 has circuit
breakers for overload protection. When the machine is operated in high temperature environments, the
breakers may tend to trip at lower loads than normal- ly.
CAUTION
Never bypass the circuit breakers. Without overload protection, the POWER ARC 5000 could overheat and/or cause damage to the equipment being used.
PREMISES WIRING
The POWER ARC 5000
meet the National Electric Code (NEC) regulations as well as city ordinances can be confusing. Matters get worse depending on whether you want the machine to be “hardwired” to the premises or only connected temporarily.
WARNING
Only a licensed, certified, trained electrician should install the machine to a premises or residential electri- cal system. Be certain that:
•The premises is isolated and no feedbacking into the utility system can occur. Certain state and local laws require the premises to be isolated before the generator is linked to the premises. Check your state and local requirements.
•A double pole, double throw transfer switch in con- junction with the properly rated double throw cir- cuit breaker is connected between the generator power and the utility meter.
Remember that the POWER ARC 5000 is intended only for backup, intermittent use. It cannot withstand
CAUTION
Certain electrical devices cannot be powered by the POWER ARC 5000. Refer to Table A.2 for these devices.
POWER ARC 5000
