ACCESSORIES |
Return to Section TOC
LISTING OF ACCESSORIES
K29 VERTICAL LIFT ADJUSTER
When mounted in the
K148 CONTACT NOZZLE AND
K149 LINC-FILLTM LONG STICKOUT EXTENSION
This Innershield and submerged arc nozzle is designed for 0.062 through 3/16 in. (1.57 through 4.76 mm) wire at high currents. When long stickout [2 to 5 (50.80 to 127.00 mm)] is required, the K149
Return to Section TOC
Return to Section TOC
Return to Section TOC
K58 MAGNETIC SEPARATOR
Useful with any submerged arc equipment. The unit removes foreign magnetic particles from reused submerged arc welding flux. Operating instructions are included with the kit.
K96 HORIZONTAL ADJUSTER
When mounted in the
K129 SUBMERGED ARC SMALL WIRE TWINARC®
The Twinarc system provides for the feeding of two small solid wires through a single wire feeder. The Twinarc assembly includes a wire reel, reel brake, shaft and mounting bracket, drive roll, idle roll assembly, dual wire guides, and nozzle and contact tip or contact tip holder. Instructions are shipped with each kit, are contained in the IM305 manual, and can be ordered as Sec. T2.5.3 K129.
K218 HORIZONTAL FILLET/LAP ATTACHMENT
This special contact assembly automatically guides the electrode when making submerged arc horizontal fillet and lap welds to ensure accurate bead placement without expensive fixtures and clamps. Installation, operating, and maintenance instructions are shipped with each kit, are contained in the IM305 manual, and can also be ordered as Sec. T2.5.4.
K219 FLUX HOPPER KIT
This flux hopper, which has an electric flux valve, can be mounted on
K223 SOLENOID KIT
The solenoid kit includes a valve to control water flow when using the cooling attachment on the K148 or K239 contact nozzle assembly. It opens when the start button is pressed and can be wired to close either when the stop button is pressed or when the arc goes out. Installation instructions are shipped with each kit.
