F-59
TROUBLESHOOTING & REPAIR
F-59
4. Remove the jumper wire from leads
#2 and #4.
5. Remove the test voltmeter and,
while welding, compare the SET
volts and ACTUAL volts meter read-
ings. Depending upon the arc volt-
age characteristics of the process
being welded, the ACTUAL reading
may vary somewhat about an aver-
age value. The average ACTUAL
reading should match the SET read-
ing within +/- 0.5 VDC. If not, refer
to the
Meter Circuit Accuracy Test
.
6. If no further tests are required,
remove all test equipment and close
and secure the access door.
VOLTMETER ACCURACY TEST (Continued)
NA-5
FIGURE F.8 CR3 RELAY
CR3 RELAY
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC