Lincoln Electric SVM103-A service manual Options/Accessories, Lincoln Electric Accessories

C-1

ACCESSORIES

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

OPTIONS/ACCESSORIES

LINCOLN ELECTRIC ACCESSORIES

The following options/accessories are available for your POWER-ARC 4000 from your local Lincoln Distributor.

Power Plug Kit (K802T) – Provides three plugs, two for the 120 volt duplex receptacle and one for the 240 volt receptacle.

Accessory Set (K875) – Includes the following:

•Twenty feet (6.1 meters) of #6 AWG electrode cable

•Fifteen feet (4.6 meters) of #6 work cable

•Headshield with No. 10 filter, work clamp

•Insulated electrode holder and sample electrodes The cables are rated at 150 amps, 40% duty cycle.

Spark Arrester (K883-1)– A field-installed kit for the 8 HP Briggs & Stratton Cool-Bore®engine. The spark arrestor attaches to the muffler to reduce the change of sparks being emitted from the muffler.

Rotor Removal Kit (S20925) – A service kit with thru and impact bolts for removing the generator rotor from the tapered engine crankshaft.

SEMIAUTOMATIC MIG WELDING WITH A LINCOLN WELD-PAK 100 OR WELD-PAK 125

In addition to using the accessories/options listed above, the POWER-ARC 4000 generator can supply power to a Lincoln ELectric Weld-Pak 100 or Weld- Pak 125 wire feed welder. The Weld-Pak comes with all the supplies needed for Flux-Cored Arc Welding (FCAW).

A K610-1 MIG (Metal Inert Gas) Conversion Kit is also available for the Weld-Pak. The kit provides every- thing needed for Gas Metal Arc Welding (GMAW) or MIG processes. Contact your local authorized Lincoln representative for details about the Weld-Pak and MIG Conversion Kit.

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

BRIGGS AND STRATTON ACCESSORIES

The following options/accessories are available for your POWER-ARC 4000 from your local Briggs & Stratton Distributor.

Foam Pre-cleaner (REF 271794) – Provides a foam cleaner for replacement around the paper cartridge air cleaner. Increases protection in extremely dusty or dirty environments.

Oil Gard® Low Oil Shutdown Kit (REF 398182) – Installs in the crankcase access port standard on all POWER-ARC models. Senses low oil conditions and automatically stops the engine. The engine cannot be restarted until sufficient oil is added.

Super Lo-Tone®Muffler - Square (REF 494221) – Replaces the round Lo-Tone muffler that comes installed on the engine. Limits exhaust noise but reduces maximum generator output by 200-300 watts.

Muffler Guard (REF 494868) – Installs onto the muf- fler with a supplied bracket. Protects against acci- dental contact with a hot muffler. Must not be used in tandem with both a deflector and a spark arrester.

POWER-ARC 4000