ACCESSORIES | ||
|
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
INSTALLATION OF THE K590-6 WATER COOLING KIT
WARNING
ELECTRIC SHOCK can kill.
• Turn the input power OFF at the dis- connect switch before working on this equipment.
•Do not touch electrically hot parts.
•Only qualified personnel should install, use or service this equipment.
The
Tools required:
•3/8" wrench
•5/16" nut driver
•medium flat bladed screw driver
•cutting tool
1.Turn power off at the welding power source.
2.Remove the screws securing the case to the inner module using a 3/8" wrench.
3.Remove the module from the case by lifting the front of the module approximately .25" (6 mm) and then sliding forward.
4.Use a 5/16" nut driver to remove the screws holding the water cooling cover on the case front of the inner module and on the rear of the case.
5.Install the fitting and hose assembly to the case front. Route the hoses along the bottom of the inner module and out through the cutout of the cover. Slide the module back into the case.
6.Secure the module to the case with the screws. (Shown in Step 2)
7.Install the fitting assembly to the rear of the case
ALUMINUM CASE
PLASTIC CASE
8.Slide the hose clamps on to the hoses. Trim the hoses to length so that they lay flat on the case bot- tom. Slide hose clamps on the hose. Slide the hoses on to the fittings on the case rear and secure with the hose clamps.
