6. BASIC CONSOLE PROGRAMMING

◆In a new installation, when power is first applied, the Console’s master user code is “1234”.

CHANGE THE MASTER USER CODE

✍NOTE: Local programming must be entered on the Console’s keypad, not on a wireless remote keypad.

Press [∗] (clears keypad if any other keys have been pressed).

Place the Console in Test Mode (enter 1234 and press [TEST]).

❇A “gong” and four “beeps” will sound.

Enter the Setup Mode from Test Mode, enter the 1234 then press [TEST].

❇A “gong” and five “beeps” will sound. Enter 99 then press [HOME].

Enter any combination of 1-5 digits for the new master user code, then press [AWAY].

✍NOTE: For maximum security, a three to five digit code is recommended.

Press and hold the [OFF] key for 3 seconds to exit program mode.

Test the new master user code by entering it then pressing [TEST].

Log the master user code in the box below.

MASTER USER CODE

✍NOTE: The master user code can be used to enter Setup Mode. The restricted user codes cannot. To create restricted user codes, see the “Advanced Programming” section of this manual.

PROGRAM THE SENSORS INTO THE CONSOLE’S MEMORY

◆Each wireless sensor that is going to be used with the Console must be programmed into the Console’s memory.

Start with the Console in Test Mode (enter any user code and press [TEST]).

ENTERING

SETTING A

SETUP

NEW MASTER

MODE

USER CODE

START IN OFF

START IN SETUP

CLEARS

 

KEYPAD

PROGRAMMING

 

 

STEP #99

DEFAULT

 

MASTER

PROGRAM

USER

 

CODE

 

 

NEW

1 GONG &

MASTER

4 BEEPS

USER

(TEST MODE)

CODE

DEFAULT

STORE

MASTER

CODE

USER

 

CODE

HOLD FOR

 

3 SECONDS

 

TO EXIT

1 GONG &

SETUP

 

5 BEEPS

DONE

(SETUP MODE)

 

START IN TEST

Enter the Setup Mode from Test Mode, enter the master user code then press [TEST].

❇A “gong” and five “beeps” will sound.

❇The sensor status indicators will light for any sensors programmed into the Console.

Enter an unused sensor number from 01-12 (you must enter two digits, example: 5 = 05)

❇The sensor indicator light will flash for the sensor number selected.

Activate the sensor by sending a test or alarm signal (be sure the sensor’s battery is connected or that its battery protection strip is removed).

TEST

MASTER USER CODE

1 GONG &

5 BEEPS

NEW SENSOR NUMBER

❇A single “bing” tone will sound and the sensor status indicator for that sensor will stay lit.

Enter another sensor number or exit Setup Mode by holding the [OFF] key for three seconds.

ACTIVATE SENSOR

DONE

12