4 BY 2 FORMAT POINT ID REPORTING CODES
4 BY 2 FORMAT POINT ID ALARM REPORT CODES
◆Refer to the 4 by 2 Format Point ID Reporting Code table to view/edit the alarm reporting
codes for each of the 12 sensors. The | DVS12K24.EPS | |
communicator will send these codes if Point |
|
|
|
| |
ID is enabled and any sensor triggers an | PROGRAMMING STEPS |
|
alarm. The factory settings are listed, along | #210 TO #221 |
|
|
| |
with a blank area to write in the new |
|
|
installation values. | PROGRAM |
|
✍NOTE: Be careful not to duplicate codes unless | 0 - 99 FOR SENSOR |
|
the Central Station requires specific codes for |
| |
ALARM CODE |
| |
certain types of sensors. | (0 = NO REPORT) |
|
◆ Each programming function is performed with | STORE PROGRAM |
|
similar keystrokes. After the system is in |
|
|
|
| |
Setup Mode, enter the programming step |
|
|
number, press the [HOME] key (HOME = |
|
|
program), enter the new value, and press the |
|
|
[AWAY] key (AWAY = store). |
|
|
|
|
|
4 BY 2 FORMAT POINT ID TROUBLE REPORT CODES |
|
|
◆Refer to the 4 by 2 Format Point ID Reporting
Code table to view/edit the trouble reporting | PROGRAMING STEPS | |
codes for each of the 12 sensors. The | ||
#234 TO 245 | ||
communicator will send these codes if Point | ||
| ||
ID is enabled and any sensor has a low battery |
| |
or trouble condition. The factory settings are | PROGRAM | |
| ||
listed, along with a blank area to write in the | 0 - 99 FOR SENSOR | |
new installation values. | TROUBLE CODE | |
✍NOTE: Be careful not to duplicate codes unless | (0 = NO REPORT) | |
STORE PROGRAM | ||
the Central Station requires specific codes for |
certain types of sensors.
◆Each programming function is performed with similar keystrokes. After the Console is in Setup Mode, enter the programming step number, press the [HOME] key (HOME = program), enter the new value, and press the [AWAY] key (AWAY = store).
40