Linksys SPA 900 SERIES manual Miscellaneous Line Key Settings, Line Key LED Pattern

Chapter 5 Linksys IP Phone Field Reference

Phone Tab

Field	Description
Extension	Select an extension to be used for this line key. Choices are:
	One-line phone: 1 or disabled,
	Four-line phone: 1, 2, 3, 4, or disabled.
	Six-line phone: 1, 2, 3, 4, 5, 6, or disabled.
	Defaults to 1.
Short Name	A short label shown on the LCD display for Line key 1/2/3/4/5/6.
(Not applicable to SPA901)
Share Call Appearance	Yes indicates that Line Key 1/2/3/4/5/6 is a shared call appearance. Otherwise this call
(Not applicable to SPA901)	appearance is not shared (in other words it is private).
	Defaults to no.

Miscellaneous Line Key Settings

This section does not apply to the WIP310 wireless phone.

Field	Description
SCA Line ID Mapping	Specifies the shared call appearance line ID mapping. Choose Vertical First or Horizontal
	First. Each LED can hold two calls and the first call on an LED makes it light up. Horizontal
	first means the second call makes the same LED flash. Vertical first means the second call
	lights up the next LED.
	For example, if Extension 101 is assigned to two LEDs, and Vertical First is selected, the sec-
	ond call on Extension 101 lights up the second LED. The third call makes the first LED flash,
	and the fourth call makes the second LED flash.
	If Horizontal First is selected, the second call on Extension 101 makes the first LED flash.
	The third call lights up the second LED, and the fourth call makes the second LED flash.
SCA Barge-In Enable	Enables the SCA Barge-In.
	Defaults to no.

Line Key LED Pattern

Line key LED colors are described in “Line Key LEDs” section on page 3-22.

Note None of the following parameters apply to the SPA901.

This section does not apply to the WIP310 wireless phone.

Field

Idle LED

Description

LED pattern during the Idle state, where the call appearance is not is in use and is available to make a new call. Leaving this entry blank indicates the default value of c=g.

	Linksys IP Phone Administrator Guide
Firmware Version 5.1		5-31