Wireless-G PrintServer
The Protocol Tab - SNMP
Use this screen to view or change the PrintServer’s SNMP (Simple Network Management Protocol) settings.
The PrintServer supports SNMP, which allows network administrators to monitor and control the PrintServer through the use of network management platforms, such as HP OpenView.
The appropriate MIB file must be imported into your SNMP management program using the
General
SysContact. Enter the name of the contact person in the SysContact field.
SysLocation. Enter the location of the contact person in the SysLocation field.
Management Stations
Station No. Select the number of the management station from the Station No.
IP Address. Enter the IP address of the management station running the SNMP program.
Community. Enter the name of the SNMP community, which is usually public or private.
Access. Select the level of access for this management station, Not Accessible,
Trap Receivers
Receiver No. Select the number of the trap receiver from the Receiver No.
IP Address. Enter the IP address of the trap receiver that will be sent the trap messages or notifications.
Community. In the Community field, enter the name of the SNMP community, which is usually public or private.
Enable with Severity level. To designate a severity level, click the checkbox next to Enable with Severity level. From the following
Click the Save button to apply your changes, or click Cancel to cancel your changes.
Chapter 6: Configuring the PrintServer Using the
Figure 6-5: Protocol Tab - SNMP
23
The Protocol Tab - SNMP
