Installing the Camera
Installing the Camera
Before you install the camera, carefully plan where and how it will be positioned, and where you will route the cable that connects the camera to the power adapter.
• Before starting permanent installation, verify its performance by observing the image on a monitor when camera is positioned in the same location/position
where it will be permanently installed
Installation Warnings
Figure 2.0 Attach stand to mounting surface
• Aim the Cameras to best optimize the viewing area: Select a location for the camera that provides a clear view of the area you want to monitor, which is free from dust, and is not in
• Avoid installing the cameras where there are thick walls or obstructions between the Cameras and the Receiver*
• Select a location for the camera that has an ambient temperature between 14°F~122°F
To install the camera:
1. Use the included mounting screws to | Figure 2.1 Attach the camera to the stand |
mount the stand to the mounting surface: |
|
•Mark the position of the screw holes on the wall
•Drill holes and insert the drywall plugs as needed
•Firmly attach the stand to the wall using the provided screws
2.Screw on the wireless antenna to the rear panel of the camera.
3.Attach the camera to the mounting stand. Adjust the angle of the camera until the desired view is set. Tighten the thumbscrews to secure the desired camera position.
4.Connect the black power cable extending from the camera to the cable of the power adapter; plug in the power adapter to an outlet or surge protector.
NOTE: You can install additional cameras (maximum of 4 cameras). When adding cameras that were not included in the original box, you will need to pair the cameras with the receiver. For details, see “Appendix C: Adding Cameras” on page 57.
13
