Lowrance electronic EP-60R Change Engine Active only with multiple-engine setting

3.Select UNCFG FF and press MENU. The following message will appear: Hit Menu to Cfg Flow Sns. Press MENU and the Configuration options menu will appear.

NOTE:

If your unit is set to a Configuration Options menu configuring a fuel flow. The configured as Eng FFlow.

single-engine configuration, the will not appear when you are fuel flow will automatically be

4.Select the desired option and press MENU. You will be directed to the Bus Devices list. Configure remaining fuel flows by following the steps above.

To unconfigure a fuel flow:

You will use the Unset Engine command when you want to unconfigure a fuel flow.

To unset engine:

1.Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press MENU.

2.Highlight B. DEVICES and press MENU. After a few moments, the Bus Devices list will appear.

3.Select the fuel flow you want to unconfigure and press MENU.

4.Highlight UNSET ENGINE and press MENU which will launch the following message: Hit Menu to Unset Dev Name.

5.Press MENU and you will be taken back to the Bus Devices list. The newly unconfigured fuel flow will be displayed as UNCFG FF.

To reconfigure a fuel flow:

You will use the Change Engine command to reconfigure a Fuel Flow. Change Engine, however, will only appear on your LMF-200 menu if you have more than one engine. If you want to reconfigure a fuel flow, but all the fuel flows on your vessel are configured, you first will have to unconfigure a fuel flow to free up its configuration name.

If all three fuel flows are configured, which means there is no name configuration available, follow the first set of instructions. If the desired configuration name is available, follow the second set of instructions.

Change Engine (Active only with multiple-engine setting)

The Change Engine command allows you to change the configuration name of a fuel flow. The steps below show how to switch the configuration name of a fuel flow from Port to Starboard.

11