4.Highlight FILL TANK and press ENTER. The following confirmation message will appear: Are you sure you wish to Fill Tank?
NOTE:
You must use the unit’s Fill Tank command when filling your fuel tank to keep the fuel flow updated with correct information on the amount of fuel in the tank.
5.Select YES and press ENTER. The following confirmation message will appear: Do you wish to
6.Highlight NO and press ENTER.
7.Take your vessel out on the water and burn at least five gallons of fuel. Be sure you run only ONE engine — the engine connected to your fuel flow.
8.Fill up your tank again, noting how much fuel you added to the tank. Compare that number to the Fuel Used figure displayed on your display unit's screen.
If the amount of fuel you added to the tank and the fuel used figure are off by more than 3 percent, we recommend the fuel flow be calibrated.
To calibrate a fuel flow:
9.Fill up your tank. Press MENU twice, select NMEA 2000 or NETWORKING and press ENTER.
10.Highlight FUEL MANAGEMENT and press ENTER. Highlight TANK LOCATION and press ENTER.
11. Select the desired tank location and press ENTER.
12.Highlight FILL TANK and press ENTER. The following message will appear: Are you sure you wish to Fill Tank? Select YES and press
ENTER.
13.The following message will appear: Do you wish to
14.Repeat these steps for each
Engine Operations
The lower half of the Fuel Management menu covers Engine Operations, which include: Engine Select, Reset Calibration, Reset Trip and Reset Seasonal.
Engine Select
Engine Select allows you to choose the desired engine when resetting calibration, resetting trip fuel and resetting seasonal fuel.
41
