5.You will be taken back to the Bus Devices list, where the fuel flow you selected (formerly Port FFlow) will be listed as Stbd FFlow. If the newly configured fuel flow is not shown, refresh the Bus Devices list.
Reset
The Reset command in the Fuel Flow level menu will clear the sensor’s configuration and calibration settings.
NOTE:
After using the Reset command, you will have to
To reset fuel flow settings:
1.Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press MENU.
2.Highlight B. DEVICES and press MENU. After a few moments, the Bus Devices list will appear.
3.Select the desired fuel flow and press MENU. Highlight RESET, press MENU and the following message will appear: Hit Menu to Rst Values.
4.Press MENU to reset fuel flow values to default settings.
EP-60R Fuel Flow Calibration
The factory calibration settings for the
NOTE:
Make sure the fuel flow has been set as the Fuel Remaining Source; otherwise, you will not be able to calibrate the fuel flow.
Fuel Flow Accuracy
To check fuel flow accuracy, you must add the Fuel Manager page to the page screen rotation and then customize it with Fuel Used data.
To add Fuel Manager page to the display:
1.Press MENU, use the UP and DOWN keys to select PAGES and press MENU, which will open the Pages menu with the following options: Add Page, Rem Page, Autoscroll and Set
2.Select ADD PAGE and press MENU.
3.Highlight FUEL MANAGER (Fuel Mngr) and press MENU. You will be taken back to the main display.
NOTE:
Make sure the Fuel Remaining Source has been set to Fuel Flow.
13
