Lowrance electronic EP-60R installation instructions Alarm Status Tab, Restore Defaults

Alarm Status Tab

The Alarm Status tab is the second tab at the top of the NMEA 2000 Alarms page. When an alarm has been set for a device, the alarm and its current status will be shown on the Alarm Status window.

To view Alarm Status:

1.Press MENU twice, select NMEA 2000 or NETWORKING and press ENTER.

2.Select NMEA 2000 ALARMS and press ENTER.

3.Highlight the Alarm Status tab.

4.Press EXIT repeatedly to return to the main display.

Restore Defaults

The Restore Defaults command allows you to reset EP-60R Fuel Flow settings to factory defaults.

NOTE:

After using the Restore Defaults command, you will have to re- enter your engine-tank configuration. It, however, will not affect the configuration or calibration of other devices on the network.

To use the Restore Defaults command:

1.Press MENU twice, select NMEA 2000 or NETWORKING and press ENTER. A menu will appear with five options: Bus Setup, Fuel Management, NMEA 2000 Alarms, Waypoint Sharing and Backlight Synchronization.

2.Highlight BUS SETUP and press ENTER, which will open the Bus Configuration menu. A list of network devices will be at the top of the page.

3.Select the desired fuel flow and press ENTER. The Device Configuration menu will appear.

4.Highlight ADVANCED OPTIONS and press ENTER.

5.Select RESTORE DEFAULTS and press ENTER. The following message will appear: Are you sure you wish to change this device's configuration?

6.Highlight YES and press ENTER. Press EXIT repeatedly to return to the main display.

44