Lowrance electronic EP-60R installation instructions Boat Setup Reset, Fuel Remaining Source

Boat Setup Reset

If you want to access the Setup screen (Boat Setup) after an engine- tank configuration has been chosen you will have to reset the configuration to default settings.

To reset engine-tank configuration:

1.Press MENU, highlight SYSTEM SETUP and press ENTER.

2.Choose ENG/TANK CFG and press ENTER twice. The following message will appear: Press ENTER to reset Eng/Tnk Cfg.

3.Press MENU. The Setup Menu will appear with Boat Setup highlighted.

Fuel Remaining Source

The Fuel Remaining source function allows you to select the device used to measure the amount of fuel remaining in the tank. It must be set to Fuel Flow (Eng /FFlow) to work properly with the EP-60R. The Fuel Remaining Source will be set to fluid level by default.

To change Fuel Remaining Source to fuel flow:

1.Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press ENTER.

2.Highlight FUEL SETUP and press ENTER.

3.Select FUEL REM SRC (Fuel Remaining Source) and press ENTER.

4.Highlight ENG/FFLOW (Fuel Flow) and press ENTER. You are ready to configure your fuel flow sensor.

EP-60R Fuel Flow Configuration

You can have up to three fuel flow sensors installed on your vessel, one for each engine supported by the LMF-400. When accessing a fuel flow, its menu will appear with the following options: Change Engine (for two or more engines only), Fuel Warning, Unset Engine, Reset Values and Reset Calibration.

NOTE:

If, after configuring, unconfiguring or reconfiguring a fuel flow, it is not shown on the Bus Devices list, you will have to refresh the list. To do this, press MENU, select SYSTEM SETUP and press ENTER.

Highlight BUS DEVICES and press ENTER.

To configure a fuel flow:

When you configure a fuel flow, you are linking the fuel flow's location/engine on the boat to its matching configuration name in the LMF-400.

22