LSI Series 518 7.4.3Setting Up Networks, 7.4.2Installing Microsoft Windows

7.4.2Installing Microsoft Windows 2000

Install Microsoft Windows 2000 on each node. See your Windows 2000 manual for information.

Log on as administrator before you install the Cluster Services.

7.4.3Setting Up Networks

Note: Do not allow both nodes to access the shared storage device before the Cluster Service is installed. In order to prevent this, power down any shared storage devices and then power up nodes one at a time. Install the Clustering Service on at least one node and make sure it is online before you power up the second node.

Install at least two network card adapters per each cluster node. One network card adapter card is used to access the public network. The second network card adapter is used to access the cluster nodes.

The network card adapter that is used to access the cluster nodes establishes the following:

•Node to node communications

•Cluster status signals

•Cluster Management

Check to make sure that all the network connections are correct. Network cards that access the public network must be connected to the public network. Network cards that access the cluster nodes must connect to each other.

Verify that all network connections are correct, with private network adapters connected to other private network adapters only, and public network adapters connected to the public network. View the Network and Dial-up Connections screen to check the connections.

Cluster Installation

7-7