2.Click on Next in the Configure Cluster Networks dialog box.

3.Verify that the network name and IP address correspond to the network interface for the public network.

4.Check the box Enable this network for cluster use.

5.Select the option All communications (mixed network), as shown below, and click on Next.

The next dialog box configures the private network. Make sure that the network name and IP address correspond to the network interface used for the private network.

6.Check the box Enable this network for cluster use.

7.Select the option Internal cluster communications only, then click on Next.

Cluster Installation

7-21

Copyright © 2002 by LSI Logic Corporation. All rights reserved.