LSI Series 518 6.2.4Step 4: Check Jumper Settings

6.You can now add or remove DRAM modules from the MegaRAID controller, as described above.

7.Reattach the battery pack harness to J10 on the MegaRAID controller.

8.Reinstall the MegaRAID controller in the computer. Follow the instructions in this chapter.

9.Replace the computer cover and turn the computer power on.

6.2.3.2Recommended Memory Vendors

Call LSI Logic Technical Support at 678-728-1250 for a current list of recommended memory vendors.

6.2.4Step 4: Check Jumper Settings

Make sure the jumper settings on the MegaRAID SCSI 320-2 card are correct. The jumpers are set at the factory and you probably do not need to change them. Table 6.2 lists the jumpers that you should check.

Table 6.2	Jumpers for the MegaRAID SCSI 320-2

Item	Description	Type

J2	SCSI activity LED connector	4-pin header

J3	Write pending indicator	2-pin header

J4	SCSI Termination Enable Channel 0	3-pin header

J5	SCSI Termination Enable Channel 1	3-pin header

J10	Battery connector	3-pin header

J16	BIOS Enable	2-pin header

J17	Termination Power Channel 0	2-pin header

J18	Termination Power Channel 1	2-pin header

Figure 6.2 shows the location of these items on the MegaRAID SCSI 320-2 controller.

Installation Steps

6-5