Perform the following steps to verify that the network adapters are working properly:
Note: Before proceeding, you must know the IP address for each network card adapter in the cluster. You can obtain it by using the IPCONFIG command on each node.
1.Click on Start.
2.Click on Run.
3.Type cmd in the text box.
4.Click on OK.
5.Type ipconfig /all and press Enter. IP information displays for all network adapters in the machine.
6.If you do not already have the command prompt on your screen, click on Start.
7.Click on Run.
8.In the text box, type: cmd
9.Click on OK.
10.Type
ping ipaddress
where ipaddress is the IP address for the corresponding network adapter in the other node. For example, assume that the IP addresses are set as follows:
Node | Network Name | Network Adapter IP Address |
|
|
|
1 | Public Cluster Connection | 192.168.0.171 |
|
|
|
1 | Private Cluster Connection | 10.1.1.1 |
|
|
|
2 | Public Cluster Connection | 192.168.0.172 |
|
|
|
2 | Private Cluster Connection | 10.1.1.2 |
|
|
|
In this example, you would type:
Cluster Installation |
Copyright © 2002 by LSI Logic Corporation. All rights reserved.