Maxon SP200/210 Radio

the same way except that a digital burst is used instead of any audio tone.

Select one of the tone options for receive operation and press <enter>

Select Features Menu

Having accessed the Personality Programmer Screen and entered your radio’s data, press the right arrow key to access the Select Features Menu.

To disable power save mode, press <enter> when in RX delay time.

(Selection of the left arrow key or <Esc> will redisplay the previous menu.)

Scanning:

Press <enter> when scanning is highlighted, to select scanning option. Press <F1> for information on scanning routines.

To change scanning parameters and scanning routines, follow instructions on screen. For “All channel scan”, no channel information needs to be entered since it will automatically scan all channels. For “Group scan” press <enter> to set up groups. To return to main menu press <esc>.

To set up the scan “group” use the up and down arrow keys and press <space bar> to enable group. To go to screen to allow entering of channels into the group press <enter>. To select the channel use the arrow keys and press <enter>. Only the channels numbers shown in black can be selected, since the channels in white have no frequency information. To return to main menu press <esc>.

N.B To allow user entry of scan groups (via the keypad), it is necessary to select group scan with an empty group enabled. Using All Channel Scan prevents editing by the user.

Program/Print/Save

Program/Print/Save

Program Radio

Print Data

Save Data to Disk

Change Data

Program Radio

PROGRAMMING

Page 7-2

SP200/210

On selection of option 1, the following sub- window is displayed:

SWITCH OFF RADIO TO EXIT PROGRAMMING

OR PRESS ANY KEY

Please ensure radio is connected to computer and switched OFF

$$$

Please hold down the monitor button

then switch on radio

Please release monitor button after

‘uu’.

Follow the instructions displayed in the screen window. Once the monitor button has been released after the second LED flash, the following sub-window is displayed:

SWITCH OFF RADIO TO EXIT PROGRAMMING

If problems occur while programming, turn the radio off to return to a menu.

Verify that your radio is a model [radio model number]

Interrupts are disabled for programming

The radio’s light MUST be green

Please press then release monitor button. Programming: Writing ‘Word’

If problems occur during programming, check you have specified:

-the correct communication port

-the programming leads are all connected

-the radio is fitted with a charged battery

If problems do occur, turn the radio off, on and then off again.

When programming is complete, the following sub-window is displayed:

***FILENAME***

:

and the radio scrolls through with the word ‘end’.

If the radio data has not previously been saved under a filename, a filename window is displayed. If you wish to save this data to file, type an eight character filename and press <enter>.

Issue 1.0 03/01

Page 48
Image 48
Maxon Telecom SP210, SP200 service manual Select Features Menu, Scanning, Program/Print/Save, Program Radio