MAINTENANCE
Electrical |
| Connection |
|
|
|
|
|
| Leveling | Legs |
|
|
| ||||||||
Appliances | which require | electrical | power | are | equipped | Some | floors are not level. For proper baking, your range | ||||||||||||||
with | a | grounding | plug | which | must be | must | be level. | The | leveling legs | are located | on each | ||||||||||
plugged directly | into a properly | grounded | corner | of | the | base | of the | range. | Level the | range by | |||||||||||
120 volt electric'a] outlet, |
|
|
|
|
|
|
|
| turning the | legs. |
|
|
|
| |||||||
If an | ungrounded, | or | other | type | electrical |
|
|
|
|
|
|
|
| ||||||||
outlet | is |
| encountered, |
| it | is | the |
| personal |
| _ | _ |
| [ | [d [ | _ |
| ||||
responsibility |
| of the appliance | owner |
| to have |
|
|
|
|
|
|
|
| ||||||||
receptacle |
| replaced | with | a properly |
| grounded |
|
|
|
|
|
|
|
| |||||||
| electrical | outlet. |
| The |
|
|
|
|
|
|
|
| |||||||||
grounding | plug | is provided | for protection | against shock |
|
|
|
| ((_) |
|
| ||||||||||
hazards. Do not cut or remove | the third |
| grounding |
|
|
|
|
|
|
|
| ||||||||||
prong from the power cord plug. |
|
|
|
|
|
|
|
|
|
|
|
|
| ||||||||
O
Always disconnect power to appliance before servicing.
Proportional Valve Adjustment
The WARM setting should produce a stable flame when turning the knob from HIGH to WARM. The flame should be 1/8 inch or lower and nmst be stable on all
ports.
To adjust: Operate burner on HIGH for about 5 minutes to preheat burner cap. Turn knob back to WARM; remove knob, and insert a small screwdriver into the center of the valve stem. Adjust flame size by turning adjustment screw in either direction. Flame
ports.mUstbeiftlame°fsufficientadjustmentsize ist°J}eeded,bestableadjuston alloNLybUrneron the WARM setting. Never adjust flame size on a higher setting.
Light Replacement
Before replacing the oven or panel light bulb,
disconnect power to range. Be sure tim bulb and range parts are coo/. Do not touch a hot bulb with a
damp cloth as the bulb may break.
To Replace Panel Light (select models)
Grasp the top trim of' the back panel with your tbmnbs under the front edge and pull outward while lifting the
trim. Remove the bulb and replace it with an 18 watt fluorescent tube. Snap the top trim back into place and
restore the power. Reset the clock.
_....,__
F-
To Replace Oven Light
Carefully unscrew the lens cover (select models) with a &y potbolder. "very carefully remove the bnlb with the potbolder. Replace witb a 40 watt appliance bulb.
Reconnect the power to the range and reset the clock.
PAGE 16
