Maytag W10239207B Dryer Disposal Installation Requirements, Tools and Parts, Tools needed

DRYER DISPOSAL

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Location Requirements

Tools needed:

■200 mm (8") or 250 mm (10") Pipe wrench

■200 mm (8") or 250 mm (10") Adjustable wrench

■Flat-blade screwdriver

■Phillips screwdriver

■Adjustable wrench that opens to 25 mm (1") or hex-head socket wrench

■Level

■8 mm (5/16") socket wrench

■Utility knife

■Vent clamps

■Pipe-joint compound resistant to LP gas

■Sealing gun and sealing compound (for installing new exhaust vent)

■Pliers

■Stiff-bladed putty knife

If installing a gas dryer:

Parts supplied:

Remove parts bag from dryer drum. Check that all parts were included.

■	Foot boot (4)	■ PN models: Card reader
■	Dryer foot (4)	bezel, card reader wire

IMPORTANT: Observe all governing codes and ordinances.

■	Check code requirements: Some codes limit or do not permit
	installation of clothes dryers in garages, closets, or sleeping
	quarters. Contact your local building inspector.
■	Make sure that lower edges of the cabinet, plus the back and

■ PD models: Cam for

service door lock

harness, hardware

bottom sides of the dryer, are free of obstructions to permit

adequate clearance of air openings for combustion air. See

“Recessed Area and Closet Installation Instructions” below

for minimum spacing requirements.

NOTE: The circuit diagram for this dryer is located inside the lower front panel, within the Tech Sheets.

■ Do not install on carpet.

NOTE: The dryer must not be installed in an area where it will be exposed to water and/or weather.

4