Memorex MPH6990 owner manual Mounting the base unit on a wall, Standard wall plate mounting

Raise the antenna to a vertical position.

UC374BH(MPH6990) OM ENG 6/5/02 8:57 AM Page 47

Additional Information (continued)

Mounting the base unit on a wall

Standard wall plate mounting

This phone can be mounted on any standard telephone wall plate.

1 Plug the telephone line cord to the TEL LINE jack and the AC adapter to the DC IN 9V jack.

2 Plug the telephone line cord into the telephone outlet.

3 Place the AC adapter cord inside the molded wiring channel.

4 Plug the AC adapter into a standard

120V AC wall outlet.

Note Use only the AC adapter supplied with this phone.

5

6 Align the mounting slots on the base with the mounting posts on the wall. Push in and down until the phone is firmly seated.

[Direct wall plate mounting]

If you don't have a standard wall plate, you can mount your phone directly to the wall. Before doing this, consider the following:

•Avoid electrical cables, pipes, or other items behind the mounting location. That could cause a hazard when inserting screws into the wall.

•Try to mount your phone within 5 feet of a working phone jack to avoid excessive cord lengths.

•Make sure the wall material is capable of supporting the weight of the base and handset.

•Use #10 screws (minimum length of 1-3/8 inches) with anchoring devices suitable for the wall material where the base unit will be placed.

1 Insert two mounting screws into the wall, (with their appropriate anchoring device), 3-15/16 inches apart. Allow about 1/8 of an inch between the wall and screw heads for mounting the phone.

2 Refer to steps 1 through 6 above to mount the telephone.

47