Playing a disc
Using the DVD player
During normal use the DVD player should be left in the standby state. This uses a negligible amount of electricity, but ensures that the components of the DVD player operate at maximum efficiency from the moment you start playing a disc.
If you are not going to use the DVD player for a period of several days you should switch the unit completely off, at the back panel, and disconnect it from the AC power supply.
To switch on from standby
●Press Open, *, or >(front panel), or select a source on the remote.
●Switch on any other equipment connected to the CD player which is not part of the Meridian 500 Series.
The display will flash for a few seconds. The DVD player is then ready for use.
To insert a disc
●Press Open (front panel) or Function * (remote) to open the tray.
●Place your disc, label side up, in the tray as shown below.
●Press Open (front panel), Function * (remote) or >to close the tray.
Most DVD videos start playing automatically when you close the tray.
Some DVD videos are
10
