Configuring the DVD player
54
To configure the sources
If you are using the 596 DVD Player as the controller in your Meridian system, you can use the Source config option on the Meridian Setup menu to configure each of the sources in your system.
●Highlight Source config in the Meridian Setup menu, and press Enter.
The Source configuration menu is displayed:
For each source you want to configure:
●Press the source key on the remote corresponding to the source you want to configure.
The Category, Address, and SCART switch options show the current values defined for that source. The SCART switch option only appears with the SCART version of the 596.
To change any option:
●Highlight the corresponding option in the Source configuration menu and press Enter, select the value you want to use, and press Enter to select it.
The Category identifies the type of Meridian product selected by the corresponding source. Specify
Normally the Address should be set to 1A. However if you have more than one Meridian product of the same type in your system you can use different source keys to select between them by assigning them different addresses. For example if you have two Meridian DVD players, assign one of them address 1A and the other address 2A.
For information about using the SCART switch option see To set up SCART switching, page 36.
