
0 |
|
| A – Command Line Interface |
|
|
| |
|
|
| Set Setup Command |
|
|
|
|
|
|
|
|
| Table | ||
|
|
| |
| Entry | Description | |
|
|
| |
| Eth0NetworkMask | Ethernet subnet mask address. | |
| Eth0GatewayAddress | Ethernet IP address gateway. | |
| AdminTimeout | Amount of time in minutes the switch waits before | |
|
| terminating an idle Admin session. Zero (0) disables | |
|
| the time out threshold. The default is 30, the | |
|
| maximum is 1440. | |
| InactivityTimeout | Amount of time in minutes the switch waits before | |
|
| terminating an idle Telnet command line interface | |
|
| session. Zero (0) disables the time out threshold. The | |
|
| default is 0, the maximum is 1440. | |
| LocalLogEnabled | Enables (True) or disables (False) the saving of log | |
|
| information on the switch. The default is True. | |
| RemoteLogEnabled | Enables (True) or disables (False) the recording of | |
|
| the switch event log on a remote host that supports | |
|
| the syslog protocol. The default is False. | |
| RemoteLogHostAddress | The IP address of the host that will receive the switch | |
|
| event log information if remote logging is enabled. | |
|
| The default is 10.0.0.254. | |
| NTPClientEnabled | Enables (True) or disables (False) the Network Time | |
|
| Protocol (NTP) client on the switch. This client | |
|
| enables the switch to synchronize its time with an | |
|
| NTP server. This feature supports NTP version 4 and | |
|
| is compatible with version 3. An Ethernet connection | |
|
| to the server is required and you must first set an | |
|
| initial time and date on the switch. The synchronized | |
|
| time becomes effective immediately. The default is | |
|
| False. | |
| NTPServerAddress | The IP address of the NTP server from which the | |
|
| NTP client acquires the time and date. The default is | |
|
| 10.0.0.254. |
|
| EmbeddedGUIEnabled | Enables (True) or disables (False) the SANsurfer | |
|
| Switch Manager Web applet. Changing this | |
|
| parameter to False while the applet is running will | |
|
| terminate the applet. The default is True. | |
|
|
|
|