Q-Logic SANBOX2-8C/16 manual Port option, Setup option, Switch state

0		A – Command Line Interface
		Set Command
	on
	Limits the display of information to 20 lines at a time. The page break
	functions affects the following commands: Alias (List, Members), Show
	(Alarm, Log), Zone (List, Members), Zoneset (List, Zones), Zoning (Active,
	List).
	off
	Allows continuous display of information without a break.
	port [option]
	Sets port state and speed for the specified port. The previous Set Config Port
	settings are restored after a switch reset or a reactivation of a switch
	configuration. Refer to the ”Set Port Command” on page A-51.
	setup [option]
	Changes SNMP and system configuration settings. Refer to the ”Set Setup
	Command” on page A-53.
	switch [state]
	Changes the administrative state for all ports on the switch to the state given by
	[state]. The previous Set Config Switch settings are restored after a switch reset
	or a reactivation of a switch configuration. [state] can be one of the following:
	online
	Places all ports online
	offline
	Places all ports offline.
	diagnostics
	Prepares all ports for testing.
Examples The following examples enables and disables the beacon:
	SANbox2 #> set beacon on
	Command succeeded.
	SANbox2 $> set beacon off
	Command succeeded.

59022-10 A A-37