Q-Logic SANBOX2-8C/16 manual Following is an example of the Set Config Switch command, Arbff

0			A – Command Line Interface
				Set Config Command
ARB_FF	(True /	False)		[False	]
InteropCredit	(decimal value, 0-255)			[0	]
ExtCredit	(dec value, increments of 11, non-loop only)			[0	]
FANEnable	(True /	False)		[True	]
AutoPerfTuning (True / False)				[False ]
LCFEnable	(True /	False)		[False ]
MFSEnable	(True /	False)		[False ]
VIEnable	(True /	False)		[False	]
MSEnable	(True /	False)		[True	]
NoClose	(True /	False)		[False ]
IOStreamGuard	(Enable	/ Disable / Auto)		[Disable]
PDISCPingEnable (True / False)				[True	]
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config		activate command) before it can take effect.
To discard this configuration use the config cancel command.
SANbox2 (admin-config) #>

The following is an example of the Set Config Switch command:

SANbox2 #> admin start
SANbox2 (admin) #> config edit
SANbox2 (admin-config) #> set			config	switch
A list of attributes with formatting and default values will follow.
Enter a new value or simply			press the ENTER key to accept the			current	value.
If you wish to terminate		this process before reaching the end				of the list
press 'q' or 'Q' and the		ENTER key		to do so.
AdminState	(1=Online, 2=Offline, 3=Diagnostics) [Online						]
BroadcastEnable	(True	/ False)			[False		]
InbandEnabled	(True	/ False)			[False		]
FDMIEnabled	(True	/ False)			[True		]
FDMIEntries	(decimal		value,	0-1000)	[1000		]
DefaultDomainID	(decimal		value,	1-239)	[11		]
DomainIDLock	(True	/ False)			[True		]
SymbolicName	(string,		max=32	chars)	[SANbox2		]
R_A_TOV	(decimal		value,	100-100000 msec)	[10000		]
E_D_TOV	(decimal		value,	10-20000 msec)	[2000		]
PrincipalPriority	(decimal		value,	1-255)	[254		]
ConfigDescription	(string,		max=32	chars)	[Default Config]
InteropMode	(True	/ False)			[True		]

59022-10 A A-45